Are you getting a firmware update failure message while trying to update Netgear AC1750 firmware? If your answer to this question is yes, then you have landed at the right post. Here, in this particular post, you will get to know some proven tips and tricks to fix Netgear router firmware update failure issue. Let’s get started!
Reasons Behind Netgear AC1750 Firmware Update Failed Error
Netgear AC1750 firmware update failed error continuously appears due to issue with your PC, WiFi security, internet connectivity, or your own router. Let’s have a look at a few reasons why your Netgear router firmware update fails again and again:
- You have downloaded the incorrect or corrupted firmware file.
- Poor or no internet connection.
- Faulty Netgear router’s hardware.
- Improper placement of Netgear WiFi router.
- Making use of damaged Ethernet cables.
- Connected to a wrong WiFi network.
- Incomplete Netgear AC1750 setup.
So, now that you know the reasons why you are continuously getting Netgear router firmware update failure message. Without any ado, let’s proceed further further with the solutions given below and fix the issue.
Fix Netgear AC1750 Firmware Update Failure Error
Basic Troubleshooting Tips
Before looking for the advance troubleshooting tips, walk through a few basic troubleshooting hacks given below to fix Netgear router firmware update fail issue.
- Check whether your Netgear WiFi router is receiving continuous power supply or not. Also, your router should be plugged into a damage-free wall outlet.
- Change the location of your Netgear WiFi router. Make sure to locate it at the middle of your house.
- Make sure that you have set up Netgear router properly.
- Scan your system. Remove viruses, malware, worms, or spyware.
- Make sure that you have the correct web address i.e. routerlogin.net or the Netgear router IP address i.e. 192.168.1.1 with you.
Hopefully, the above-mentioned Netgear router troubleshooting tips have helped you in fixing Netgear router firmware update failure issue. On the off chance if the same issue troubles you again and again, go with the advanced Netgear router troubleshooting tips given below. Keep reading!
Advanced Troubleshooting Tips to Fix Netgear AC1750 Firmware Update Failed Issue
- Make sure to download and install the AC1750 firmware file from the Netgear’s official site only.
- Be certain to download the TFTP i.e. Trivial File Transfer Protocol on your computer or laptop.
- Connect your Netgear WiFi router to your modem or gateway using an Ethernet cable.
- Make sure to connect your PC or laptop to a WiFi network.
- After that, install the TFTP software on your device and unzip it if needed.
- Open the TFTP software file and after that, choose the LAN adapter option.
- Now, in the Host field, carefully enter 192.168.1.1. This is the default IP of your Netgear AC1750 WiFi router.
- Click on the Firmware Update option.
- Wait for some time for your router to finish the firmware update process.
- Once your AC1750 device finishes updating the firmware, it will reboot automatically. It might take a couple of minutes or more than that to reboot the device. Till then you can have a cup of tea or coffee. But do not turn off your router – close your computer system or hit the back button.
Verdict
Just in case the Netgear router firmware update process doesn’t complete, reset AC1750 back to factory default values. But before you reset Netgear router, make sure to take the backup of the settings. Once your Netgear router resets successfully, reconfigure it.
Still receiving Netgear AC1750 firmware update fail message? Fail to complete the Netgear AC1750 setup process using the default values? Fret not! Simply contact our professionals using the comments section.