This will help save the cost of raw materials. If you have any questions, please contact me to delete it! . It can also use ordinary plastic bottles to seal, Travel Set Suppliers plus the advantages of broken crushing, can stand on the table, you can do a lot of replacement test tubes.

The bottle typically uses a hot runner mold, between the mold and the injection molding machine, there is a thermal insulation board. The lens bottle embryo is cut because the bottom gem is cut off. The content of the article comes from the network. The exhaust must be sufficient, avoiding local overheating or rupture, but the depth of the exhaust slot is generally no more than 0.

Domestic bottle embryo manufacturers use short glue-type blast embryos, and more foreign choice of long rubber ports abroad. During the blowing process, the tension distribution is uniform, the body blows is better, and the other part can be recycled.03mm, otherwise it will easily produce flying edges. The thickness is 12mm, and the high pressure must be able to withstand high pressure.

The bottle embryos are prototypes prior to plastic bottles, and the wall thickness is transparent. The quality control of the bottle embryo in the production process depends on the degree of control during the transportation process.

The quality of the bottle depends on the quality of the bottle embryos provided, it is divided into two, one is long, the other is short. In today’s petroleum resources shortage, domestic manufacturers will be more preferred for long glue bottle embryos