As shown in the figure: 2. Immediately use a dial indicator, feeler gauge, and management center card to accurately measure the parallelism and flatness of the coupling. Some put the rims in oil with high flash point to carry out oil bath heating or welding machine baking, and also use a barbecue box for heating. Gentle welder roasting. There are several different methods depending on the common special tools used for accurate measurement.

Usually, the color method is used for inspection during the assembly line. Sometimes it is also used as this kind of safety device to prevent the connected parts from bearing excessive load, with Coupling refers to the device that connects two shafts or shafts and rotating parts,China cv joint housing Suppliers and rotates together during the whole process of transmitting the driving force of fitness exercise, and does not loosen under normal circumstances.

Coupling assembly line regulations The overall coupling is divided into two categories: stiffness and flexibility. The actual heating temperature required for the coupling can be measured according to the clearance fit value of the coupling and the shaft and the regulations when the coupling is heated on the shaft. The assembly line method of the coupling on the shaft The assembly line of the coupling on the shaft is the fourth important part of the installation of the coupling.

This kind of method will also damage the mating surface, so it is often used in the assembly line of low-speed gears and small and medium-sized couplings. If the mutual cooperation is not good, it can be repaired with a frustrated knife or a gray knife to make it exceed the regulations. Inside, it is the fourth of the key quality regulations of the coupling assembly line. For rigid couplings, the parallelism and high precision of rotation of the two shafts to be connected are stipulated, and the radial direction can not produce repulsive interference.